HPE ProLiant DL380 Gen11 User Manual page 62

9. Connect the power cable to the drive backplane power connector .
10. Connect the data cables from the drive backplane to the NVMe riser .
11. Install drives or drive blanks.
Results Results
The installation is complete.
Installing a front 2SFF side-by-side drive cage Installing a front 2SFF side-by-side drive cage
About this task About this task
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to WARNING:
cool before touching them.
CAUTION: CAUTION: To prevent damage to electrical components, properly ground the server before beginning any installation
procedure. Improper grounding can cause ESD.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
HPE ProLiant DL380 Gen11 Server User Guide 62