HPE ProLiant DL380 Gen11 User Manual page 78

HPE Smart Storage Battery HPE Smart Storage Battery
The HPE Smart Storage Battery supports both HPE SR and MR storage controllers.
A single 96 W battery can support up to 24 devices.
After the battery is installed, it might take up to two hours to charge. Controller features requiring backup power are not re-enabled until
the battery is capable of supporting the backup power.
This server supports the 96 W HPE Smart Storage Battery with the 145 mm cable.
HPE Smart Storage Hybrid Capacitor HPE Smart Storage Hybrid Capacitor
The HPE Smart Storage Hybrid Capacitor supports both HPE SR and MR storage controllers.
The capacitor pack can support up to two devices.
This server supports the HPE Smart Storage Hybrid Capacitor with the 145 mm cable.
Before installing the HPE Smart Storage Hybrid Capacitor, verify that the system BIOS meets the minimum firmware requirements to
support the capacitor pack.
IMPORTANT: IMPORTANT:
If the system BIOS or controller firmware is older than the minimum recommended firmware versions, the capacitor pack
will only support one device.
The capacitor pack is fully charged after the system boots.
Installing a smart storage battery/capacitor Installing a smart storage battery/capacitor
Prerequisites Prerequisites
Be sure you have the components included with the hardware option kit.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Install the energy pack.
HPE ProLiant DL380 Gen11 Server User Guide 78