HPE ProLiant DL380 Gen11 User Manual page 137

Results Results
The installation is complete.
Installing a rear 2 SFF riser cage Installing a rear 2 SFF riser cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
The components included with the hardware option kit
The front drive bays are fully populated with 12 LFF or 24 SFF drives.
High-performance fans are installed in all fan bays.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Do one of the following:
For primary bays, remove the riser cage.
HPE ProLiant DL380 Gen11 Server User Guide 137