HPE ProLiant DL380 Gen11 User Manual page 142

12. Connect each power cord to the power source.
13. Power up the server .
Results Results
The installation is complete.
Installing primary and secondary risers Installing primary and secondary risers
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-10 Torx screwdriver
Procedure Procedure
1. Power down the server.
2. Do one of the following:
Disconnect each power cord from the power source.
Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the riser cage.
6. Remove the riser board.
7. Install the riser.
HPE ProLiant DL380 Gen11 Server User Guide 142