HPE ProLiant DL380 Gen11 User Manual page 11

Item Item Description Description
1 Power On/Standby button
and system power LED
1
2 Health LED
1
3 NIC status LED
1
4 UID button/LED
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
Facility power is not present, the power cord is not attached, no power supplies are installed, power supply failure has occurred, or the
power button cable is disconnected.
3
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
LFF LFF
Status Status
Solid green = System on
1
Flashing green (1 Hz/cycle per sec) =
Performing power on sequence
Solid amber = System in standby
Off = No power present
Solid green = Normal
Flashing green (1 Hz/cycle per sec) = iLO is
rebooting
Flashing amber = System degraded
Flashing red (1 Hz/cycle per sec) = System
3
critical
Solid green = Link to network
Flashing green (1 Hz/cycle per sec) = Network
active
Off = No network activity
Solid blue = Activated
Flashing blue:
1 Hz/cycle per sec = Remote management
or firmware upgrade in progress
4 Hz/cycle per sec = iLO manual reboot
sequence initiated
8 Hz/cycle per sec = iLO manual reboot
sequence in progress
Off = Deactivated
2
HPE ProLiant DL380 Gen11 Server User Guide 11