HPE ProLiant DL380 Gen11 User Manual page 70

9. Install drives or drive blanks.
10. Push down on the latches to lower the drive cage into place.
11. Connect the power and data cables to the drive backplane .
12. Install the riser cages .
13. Install the access panel .
14. Slide the server into the rack.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server .
Results Results
The installation is complete.
Installing a rear 2SFF stacked drive cage Installing a rear 2SFF stacked drive cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
The components included with the hardware option kit
The front bays are fully populated with 12 LFF or 24 SFF drives
High-performance fans are installed in all fan bays
Procedure Procedure
HPE ProLiant DL380 Gen11 Server User Guide 70