Objet500 User Guide
DOC-07027 Rev. I
❒ If printing the tray requires only one model material, the Printing Mode
Selection dialog box opens.
Figure 5-71 Printing Mode Selection dialog box
Note: The values displayed are the result of a quick calculation, and
represent a rough estimate of the materials and time input required to
print the job. For a more accurate calculation, click Fine Estimation.
➢ Select the appropriate printing mode.
For an explanation of printing modes, see "Printing-Mode
Selection" on page 1.
• If you require the job to be printed in High Quality mode, select this
option.
Note: The availability of High Quality mode depends on the material
selected.
• If you require the job to be printed in High Speed mode, select this
option.
• If you do not require the job to be printed either in High Quality or High
Speed mode, select Automatic.
This setting enables the Objet500 software to determine (just before
printing) the most efficient way to print the tray. Digital Material mode
is used if this removes the need to perform the Material Replacement
procedure. Otherwise, High Speed mode is used.
For example, if printing the tray requires only one of the model
materials loaded in the printer, only the two print heads using that
material are used to print models—Digital Material mode. (High
Quality and High Speed modes call for printing model material with
four heads, which would require you to perform the Material
Replacement procedure.)
5 Using Objet Studio
5-58