Table of Contents
Advertisement
Objet500 User Guide
Fine-Surface Rule
This rule considers models that have one side on which there are fine details (like
the keypad side of a telephone).
➢ The side of the model containing fine details should, when possible, be
Avoid Support-Material Rule
This rule considers models that have large holes or hollows, open on at least one
side (like a pipe or a container).
➢ It may be advantageous to print a model standing up, so Support material
DOC-07027 Rev. I
positioned face-up. This results in a smooth finish.
does not fill the hollow, even though printing the model lying down would be
much faster.
5 Using Objet Studio
5-32
Advertisement
Table of Contents
