Objet500 User Guide
4. After selecting the materials for the appropriate cartridge slots, the Cartridge
M aterial for Single Material mode
If you regularly use a certain material for printing models in single material mode,
and if this material is currently loaded in the printer, you can select it from the
drop-down menu. The wizard will take this into account when determining the
new cartridge locations. When possible, the selected material will remain in parts
of the system (cartridge slots, tubes, print block) so that it is available when next
needing it. This option is recommended if you often switch between single and
multiple-material modes because it can reduce the amount of material flushed
during replacement.
DOC-07027 Rev. I
When printing in High Speed mode (three materials), the same material is
used in both sections of each print head. The material selected for one of the
cartridge slots is also used in the other print head channel.
Figure 6-16 Manual cartridge selection—3 Model Materials
Positioning screen appears. Place the cartridges in the materials cabinet as
shown in this screen.
6 Operating and Maintaining the Printer
6-20