Table of Contents
Advertisement
Copyright
DOC-07027 Revision I
Copyright © 2006–2021 Stratasys Ltd. All rights reserved.
This documentation contains proprietary information of Stratasys Ltd. This information is supplied solely to assist
authorized users of Stratasys Objet500 3D printing systems. No part of this document may be used for other purposes.
The specifications on which this document is based are subject to change without notice.
Trademarks
Stratasys, Objet, Connex, Objet Studio, Job Manager, GrabCAD Print, GrabCAD PolyJet Server, FullCure, and PolyJet
are trademarks of Stratasys Ltd. and/or i ts subsidiaries or affiliates and may be registered in certain jurisdictions. All other
product n ames and trademarks are the property of their respective owners.
FCC Compliance
The equipment referred to in this guide has been tested and found to comply with the limits for a Class A device pursuant
to part 15 of the FCC rules. These limits provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. Stratasys 3D printing systems generate, use and can radiate radio-
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be r equired to correct the interference at his own expense.
The 3D printer referred to in this guide contains a transmitter module, FCC ID YH6-MATCAB.
NOTE: Stratasys is not responsible for radio or TV interference caused by unauthorized modification to this equipment.
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the
equipment.
Equipment Recycling
In the European Union, this symbol indicates that when the last user wishes to discard a product, it must be sent to
appropriate facilities for recovery and recycling. For information about proper disposal, check your purchase contract, or
contact the supplier of the equipment.
Limitation of Liability
The product, software or services are being provided on an "as is" and "as available" basis. Except as may be stated
specifically in your contract, Stratasys Ltd. expressly disclaims all warranties of any kind, whether express or implied,
including, but not limited to, any implied warranties of merchantability, fitness for a particular purpose and non-
infringement.
You understand and agree that Stratasys Ltd. shall not be liable for any direct, indirect, incidental, special, consequential
or exemplary damages, including but not limited to, damages for loss of profits, goodwill, use, data or other intangible
losses (even if Stratasys has been advised of the possibility of such damages), resulting from: (i) the use or the inability to
use the product or software; (ii) the cost of procurement of substitute goods and services resulting from any products,
goods, data, software, information or services purchased; (iii) unauthorized access to or alteration of your products,
software or data; (iv) statements or conduct of any third party; (v) any other matter relating to the product, software, or
services.
The text and drawings herein are for illustration and reference only. The specifications on which they are based are
subject to change. Stratasys Ltd. may, at any time and without notice, make changes to this document. Stratasys Ltd., for
itself and on behalf of its subsidiaries, assumes no liability for technical or editorial errors or omissions made herein, and
shall not be liable for incidental, consequential, indirect, or special damages, including, without limitation, loss of use, loss
or alteration of data, delays, or lost profits or savings arising from the use of this document.
DOC-07027 Rev. I
Advertisement
Table of Contents
