Table of Contents
Advertisement
Objet500 User Guide
The waste container consists of a plastic container inside a cardboard box. You
typically dispose of the entire waste container—including the box. Therefore, you
must assemble a new box and insert a new plastic container before you can
install it in the printer.
Replacement boxes, plastic containers, and sealing caps are supplied in the
printer start-up kit and in the preventive-maintenance kit.
To prepare a new waste container:
1. Assemble the cardboard box, making sure to punch out the perforated
2. Place a new plastic container into the box.
To replace the waste container:
1. Locate the door on the lower-left side of the printer.
2. Push in the top-center of the door to release the latch and open the door.
3. Carefully slide out the waste container to remove it from the printer.
4. Place the new waste container next to the full container.
5. Unscrew the cap securing the waste drain tube and connect it to the new
6. Close the full container with the cap supplied with the new waste container.
7. Close the new waste container box.
8. Position new the waste container in the printer.
DOC-07027 Rev. I
sections.
Note: Do not close the box until you connect the waste drain tube from the
printer.
Figure 6-130 Accessing the waste container
container.
If necessary, use tape to hold it closed.
Note: Make sure that the waste drain tube is not crimped or twisted, and that
it is not pinched by the container.
6 Operating and Maintaining the Printer
6-91
Advertisement
Table of Contents
