Objet500 User Guide
5. Loosen the two screws securing the suction tube on the print block.
6. Lift the suction tube to secure it in a raised position.
7. Remove the two screws securing the covering of the roller waste collector
Be very careful to save the covering screws. These are special screws; if they
are lost, you need to order replacements.
8. Remove the covering by pulling it out, and then lower it.
DOC-07027 Rev. I
Figure 6-40 Lifting the suction tube
and remove it.
Figure 6-41 Removing the roller waste collector screws
6 Operating and Maintaining the Printer
6-39