Table of Contents
Advertisement
Objet500 User Guide
14. U sing a 2.5-mm hex key, secure the clamp to the UV reflector, and continue
15. I nspect the new UV reflector, and make sure that a black strip is attached to
16. D iscard the old UV reflector and lamp.
Dispose of the used UV lamp in accordance with environmental and safety
requirements.
DOC-07027 Rev. I
Figure 6-119 Pushing the UV lamp into place
with step
.
25
Figure 6-120 Attaching the UV lamp clamp
the inside of it. If not, install one—on the side of the reflector opposite (not
next to) the print block.
Note: Extra black strips are included in the printer Start-Up Kit. If necessary,
you can remove the black strip from the old reflector and install it in the new
reflector (as long as the black paint has not faded).
6 Operating and Maintaining the Printer
6-80
Advertisement
Table of Contents
