Objet500 User Guide
11. L oosen the screws on the door of the compartment protecting the print-head
12. P ull the print-head driver card out of its socket so that the head is free (A), and
13. M ake sure that along with the head, you remove the two rubber O-ring seals.
Important
If the seals are not removed with the head, they are probably stuck to the print
block housing. If so, remove them.
DOC-07027 Rev. I
driver cards (A), then pull and lift up the door (B).
Figure 6-78 Opening the print-head compartment
remove it from the bottom of the print block (B).
Figure 6-79 Releasing the print-head driver card to remove the head
Figure 6-80 O-ring seals on the print head
6 Operating and Maintaining the Printer
6-60