Table of Contents
Advertisement
Objet500 User Guide
9. Click Next to begin the material replacement process in the printer.
Symbols:
The correct cartridge is in this slot.
No cartridge (or the incorrect cartridge) is in this slot.
The cartridge in this slot has insufficient weight to complete the material
10. R eplace material cartridges as necessary, according to the instructions in the
11. C lick Start.
12. R ead the warning message, and click OK.
If you continue, you must complete the material replacement process before
you can produce models. To replace material cartridges at another time, click
Cancel. If you continue (by clicking OK) and you do not complete the process,
you will need to run the wizard again before producing models.
DOC-07027 Rev. I
The Cartridge Positioning screen appears, showing you the new location of
all cartridges in the material cabinet.
Figure 6-11 Cartridge placement
replacement process.
The expiration date of the cartridge in this slot has passed.
wizard screen.
6 Operating and Maintaining the Printer
6-16
Advertisement
Table of Contents
