Table of Contents
Advertisement
Objet500 User Guide
2. In the opening screen, click Next.
3. If the printer cover is not closed, a screen appears, prompting you to close the
4. Choose whether you want to produce models in Single Material mode or in
5. In the Required materials section of the wizard screen, select one or more
6. For Model materials, select Both if you need to load two replacement
DOC-07027 Rev. I
cover. Confirm that it is closed and click Next.
Figure 6-10 Material replacement options
In the Material Replacement Options screen, you select the settings that
determine how the wizard replaces material currently in the system with
newly loaded material.
Digital Material ( "multiple-materials") mode.
Single Material mode
Four print heads are used to print, using one Model material.
❒ This mode is required to produce build trays with the High Quality setting,
and to produce trays with the High Speed setting, using only one Model
material.
Digital Material mode
Each of the Model materials loaded is used in two of the print heads.
❒ If only one of the Model materials is required for printing, models are
produced using two print heads. This makes it unnecessary to replace the
other Model material.
❒ If Model-material substitution is allowed, the printer produces trays with
the High Speed setting using a mixture of Model materials (see "Model
Material Substitution" on page 1).
replacement materials cartridges.
cartridges.
Loading one replacement cartridge is more economical because it potentially
requires less flushing of material currently in the system. However, when one
cartridge is not sufficient, loading two cartridges enables continuous printing
6 Operating and Maintaining the Printer
6-14
Advertisement
Table of Contents
