Objet500 User Guide
16. P ush the head up until you hear it click into place, in both front and rear
17. L ower the door of the print head compartment, and tighten the screws to lock
18. T ighten the upper and lower screws that secure the print head in the print
19. I n the Replace print heads screen, select the check box to confirm that you
DOC-07027 Rev. I
holders.
Figure 6-83 Pushing the head into place in the print block
it in place.
block (see Figure 6-76 on page 6-59).
Note: Hand-tighten these screws. Do not use a screwdriver.
have replaced the head(s), and click Next.
Figure 6-84 Head replacement confirmation
6 Operating and Maintaining the Printer
6-62