Table of Contents
Advertisement
Objet500 User Guide
SUP705 (FullCure705) and SUP706 Support material can be removed from
printed models using the following methods, in this order:
1. by hand
2. water pressure (in a suitable cleaning unit)
3. SUP705: 1% caustic soda solution (recommended for a smooth finish)
Removing Support by Hand
While wearing protective gloves, break away excess Support material on the
outside of the model. For delicate models, use a toothpick, pin or small brush
after dipping the model in water.
• For SUP705, after breaking away excess Support material, soak the model in
• For SUP706, after breaking away excess Support material, soak the model in
Removing Support with Water Pressure
For most models, the most efficient way to remove Support material is by using a
high-pressure water jet. One suitable system is the Balco WaterJet cleaning unit.
This device is marketed by Stratasys.
Figure 7-1 B alco WaterJet Cleaning Unit
To clean a model using this device, you manipulate it and the water using the
built-in, waterproof sleeves. A pump turns ordinary tap water into a high-
pressure jet. A wiper keeps the window clear.
Use caution when cleaning delicate models with high-pressure water
systems.
DOC-07027 Rev. I
SUP706: 2% caustic soda and sodium metasilicate solution
a 1% caustic soda solution (see "Removing SUP705 with Caustic Soda" on
page 7-4).
a 2% caustic soda and sodium metasilicate solution (see "Removing SUP706
with Caustic Soda and Sodium Metasilicate" on the next page).
7 Handling Printed Models
7-3
Advertisement
Table of Contents
