Interval Wiping - MIMAKI TxF150-75 Operation Manual

Chapter 3 Settings
Automatic nozzle checking (Cleaning Check) after auto
cleaning can also be set.
With the screen in local mode, select
1
[MENU] > [SETUP], and then press the
[ENTER] key.
• SETUP options are displayed.
Select a SETUP option from 1 to 4 and
2
press the [ENTER] key.
• The SETUP menu is displayed.
Select [AUTO CLEANING] and press the
3
[ENTER] key.
Select a setting value and press the
4
[ENTER] key.
• Setting value: FILE / LENGTH / TIME / OFF
Select a setting value and press the
5
[ENTER] key.
• Setting values vary depending on your selection
in the previous step.
• For FILE: 1–1000 files
• For LENGTH: 0.1–100.0 m (in 0.1 m increments)
• For TIME: 10–120 min. (in 10 min. increments)
Select [TYPE] and press the [ENTER] key.
6
• Select the type of cleaning and press the
[ENTER] key.
• Setting value: NORMAL / SOFT / HARD
Select [Cleaning Check] and press the
7
[ENTER] key.
Select a setting value and press the
8
[ENTER] key.
• Setting value: ON / OFF
• Depending on the state of heads and other fac-
tors, this function may not be able to restore
print quality that has declined. In this case, con-
tact your dealer, service office, or call center.

Interval wiping

After the specified amount of time has elapsed, the head
nozzle surface is automatically cleaned to remove ink
droplets adhering to the nozzle surface.
Set an interval in case of nozzle clogging, deflection,
falling ink droplets, or similar symptoms.
With the screen in local mode, select
1
[MENU] > [SETUP], and then press the
[ENTER] key.
• SETUP options are displayed.
Select a SETUP option from 1 to 4 and
2
press the [ENTER] key.
• The SETUP menu is displayed.
Select [INTERVAL WIPING] and press the
3
[ENTER] key.
3-6
Select a setting value and press the
4
[ENTER] key.
• Setting value: 3–255 min. / OFF