Turning The Power On/Off; Turning The Power On; Turning The Power Off - MIMAKI TxF150-75 Operation Manual

Turning the Power On/

Off

Turning the power on

The machine has two power switches.
[END/POWER] key:
Normally, use this key to turn the power on or off.
Main power switch:
On the side of the machine.
• Do not turn off the main power supply. Turning
off the main power supply will disable the auto-
matic maintenance function (including nozzle
clogging prevention function and ink discharge
channel cleaning function). This increases the
risk of ejection failures (such as nozzle clogging
or deflection).
Turn the main power switch on.
1
• The firmware version is displayed when the power
is turned on, and initial operations are performed.
[END/POWER]
key
Press the [END/POWER] key to turn on
2
power.
• The machine enters local mode.
Turn on the connected computer.
3
• Make sure the maintenance cover is closed
before turning the machine on.

Turning the power off

After using the machine, press the [END/POWER] key
on the front to turn it off.
Before turning the machine off, check the following:
• If the machine is receiving RIP data from the computer,
or if any data has not been printed yet
• If the carriage has returned to the capping station
• If any errors have occurred (
messages])
Turn off the connected computer.
1
Hold down the [END/POWER] key to turn
2
off the machine.
• Do not turn off the main power switch on the side
of the machine.
 Do not turn the main power switch off.
 Check the carriage position before turning the
Main power
switch
 Do not turn the power off during printing.
 Press the [END/POWER] key to turn off the
P.5-6 [Error
Chapter 2 Basic Operations
• To use the machine again, press the [END/
POWER] key.
Precautions on turning the power off
Turning off the main power switch will prevent
automatic maintenance from working, which may
result in nozzle clogging.
machine off.
Turning the power off without the carriage returned to
the capping station may result in the head nozzle
surface drying out, which is a factor for nozzle
clogging. In this case, turn the machine on again and
confirm that the carriage has returned to the capping
station before turning the machine off.
This may prevent the head from returning to the
capping station.
power before turning off the main power
switch.
If you must turn off the main power switch when
moving the machine or clearing an error, be sure to
hold down the [END/POWER] key on the front and
confirm that the operating panel display is off before
turning off the main power switch.
[END/POWER]
key
2-3
2
2
2
5
6