MIMAKI TxF150-75 Operation Manual page 51

• Depending on the server used, the machine
may not be able to send emails unless you set
up an email address corresponding to your
account.
Select [Authentication] and press the
8
[ENTER] key.
Specify the method of authentication and
9
press the [ENTER] key.
• Sets the method of SMTP server authentication.
• If you have selected OFF, go to step 17.
Select [USER NAME] and press the
10
[ENTER] key.
Specify the user name and press the
11
[ENTER] key.
   
• Press [ ] / [ ] / [ ] / [
for authentication.
• Use alphanumeric characters and symbols (up to
30 characters).
Select [PASS WORD] and press the
12
[ENTER] key.
Specify the password and press the
13
[ENTER] key.
   
[
• Press [ ] / ] / [ ] / [
authentication.
• Use alphanumeric characters and symbols (up to
15 characters).
• The password setting screen only allows you to
check the value you are currently entering.
• If you have selected [POP before SMTP], set the
items in step 13–16.
Select [POP3 Address] and press the
14
[ENTER] key.
Specify the POP3 address and press the
15
[ENTER] key.
   
• Press [ ] / [ ] / [ ] / [
the POP server name.
Select [APOP] and press the [ENTER] key.
16
Select a setting value and press the
17
[ENTER] key.
• Setting value: ON / OFF
Sending test email
With the screen in local mode, select
1
[MENU] > [MACHINE SETUP], and then
press the [ENTER] key.
• The MACHINE SETUP menu is displayed.
Select [EVENT MAIL] > [TRANSMIT TEST],
2
and then press the [ENTER] key.
] to set the user name used
] to set the password used for
] to set the POP server. Enter
Press the [ENTER] key.
3
• Results of transmission are displayed.
• If testing email transmission fails, an error code is
displayed.
Transmit Test
Failed: 12345:
Error code
• Results of testing email transmission represents
the result of transmission as performed by the
machine to the mail server. It does not indicate
that email was received at the address.
• If the recipient has set up a spam filter or the like,
email may not reach them even if the machine
indicates that it has been sent.
• If testing email transmission fails, the following
error codes are displayed.
• If the error cannot be resolved, wait a while and
try again.
• For server settings and similar information, con-
tact your network administrator or the provider.
Chapter 3 Settings
ent
3-13
1
2
3
4
5
6