Replacing The Cp Pad Set; Replacing Pinch Rollers - MIMAKI TxF150-75 Operation Manual

Chapter 4 Maintenance
Exhaust fan filter
Attach the exhaust box in its original
3
position.
• Engage the tabs at the rear of the exhaust box
onto the machine, and then push in the front side.

Replacing the CP pad set

If the CP pad set is very dirty or if ink drips onto the media,
replace with a new cap absorber.
With the screen in local mode, select
1
[MENU] > [MAINTENANCE], and then press
the [ENTER] key.
• The Maintenance menu is displayed.
Select [STATION MAINT.] > [CARRIAGE
2
OUT] > [STATION MAINT.], and then press
the [ENTER] key.
• The carriage moves over the platen.
Remove the CP pad set.
3
• Push up the two tabs at the front to remove the
cap absorber.
CP pad set
Attach the new CP pad set.
4
• Push the tabs of the CP pad set into the slits at
the rear of the C slider, then insert the tabs at the
front.
4-16
Exhaust fan BOX
5
6

Replacing pinch rollers

Replace the pinch roller with a new pinch roller if it is dirty
or severely worn out.
1
2
Tab
CP pad assembly
C slider
Press to engage the tabs
After replacement, manually return the
wiper to the rear.
Turning On the Power
• Check to confirm that the carriage returns to the
station.
• Turn off the main power supply and unplug the
power cable before carrying out maintenance.
• Do not use maintenance liquids, or alcohol, etc.
Raise the clamp lever.
Remove the O-rings holding the pinch
rollers.
• The O-rings are small. Be careful to avoid drop-
ping them into the product interior.
O-ring