Heater; Logical Seek; Drying Time - MIMAKI TxF150-75 Operation Manual

Chapter 3 Settings
• If the correction value to use does not lie in the
range of -40 to 40, adjust the printing head height
and repeat this process from step 2.
Print direction
Forms a straight line at the fourth
position from 0 in the positive
direction. In this case, the dot
position correction value is 4.0.
Do the same to enter a correction value for
6
pattern 2, and then press the [ENTER] key.

Heater

The platen incorporates a preheater, print heater, and
post-heater.
Besides setting the temperature for each, you can set the
time until the heater turns off after printing.
Type of heater
Preheater Preheats the media before printing to
suppress rapid temperature change.
Print heater Helps prevent ink bleeding.
Post-heater Allows ink to dry after printing.
With the screen in local mode, select
1
[MENU] > [SETUP], and then press the
[ENTER] key.
• SETUP options are displayed.
Select a SETUP option from 1 to 4 and
2
press the [ENTER] key.
• The SETUP menu is displayed.
Select [HEATER] and press the [ENTER]
3
key.
Enter the heater temperatures, then press
4
the [ENTER] key.
• Heater selection: Select with [  ] / [  ]
• Temperature setting: Set with [  ] / [  ]
• To give priority to RIP settings, use "Host" as the
setting value.
Select [OFF TIME] and press the [ENTER]
5
key.
Set the time until the heater turns off after
6
printing and press the [ENTER] key.
• To fully deactivate heating, press [FUNC3] (OFF)
in step 3. You can also increase all heating tem-
peratures by 10°C by pressing [FUNC1].
• Heaters automatically return to the specified tem-
perature if keys are pressed or data is received
before the off-time set in step 6 elapses.
3-4
Function

Logical seek

Modifies carriage operation during printing.
Carriage movement with logical seek off
Unidirectional printing
Machine width
Print area
Red arrow: Carriage movement
Carriage movement with logical seek on
Unidirectional printing
Machine width
Print area
Red arrow: Carriage movement
With the screen in local mode, select
1
[MENU] > [SETUP], and then press the
[ENTER] key.
• SETUP options are displayed.
Select a SETUP option from 1 to 4 and
2
press the [ENTER] key.
• The SETUP menu is displayed.
Select [LOGICAL SEEK] and press the
3
[ENTER] key.
Select a setting value and press the
4
[ENTER] key.
• Setting value: HOST / ON / OFF

Drying time

These setting items control ink drying time.
• SCAN: Set the ink drying time per scan. (In bidirectional
printing, the machine pauses for the time set
after each outward and return scan.)
• PRINT END: Set the ink drying time after printing is fin-
ished.
• "SCAN" as set on machine is identified as
"Pause Time per Scan" in RasterLink.
• The print end setting cannot be set on the Ras-
terLink side. Setting the machine setting to
"Host" will print with "Print End=0 min."
With the screen in local mode, select
1
[MENU] > [SETUP], and then press the
[ENTER] key.
• SETUP options are displayed.
Select a SETUP option from 1 to 4 and
2
press the [ENTER] key.
• The SETUP menu is displayed.
Bidirectional printing
Machine width
Bidirectional printing
Machine width