Setting The Network - MIMAKI TxF150-75 Operation Manual

With the screen in local mode, select
1
[MENU] > [MACHINE SETUP], and then
press the [ENTER] key.
• The MACHINE SETUP menu is displayed.
Select [SPACE FEED MODE] and press the
2
[ENTER] key.
Select a setting value and press the
3
[ENTER] key.
• INTERMITTENT: Feeds intermittently based on a
fraction of a printing pass.
• CONTINUOUS: Feeds by skipping blank parts all
at once.

Setting the network

With the screen in local mode, select
1
[MENU] > [MACHINE SETUP], and then
press the [ENTER] key.
• The MACHINE SETUP menu is displayed.
Select [NETWORK] > [Check IP
2
ADDRESS], and then press the [ENTER]
key.
• The machine's current IP address is displayed.
• After you have checked it, press the [ENTER] key.
• It takes some time after a network connection is
established until the IP address is determined.
"0.0.0.0" is displayed when the IP address has
not been determined yet.
Select [Check MAC ADDRESS] and press
3
the [ENTER] key.
• The machine's current MAC address is displayed.
• After you have checked it, press the [ENTER] key.
Select [DHCP] and press the [ENTER] key.
4
Select a setting value and press the
5
[ENTER] key.
• Setting value: ON / OFF
• Set to ON to use an IP address set by the DHCP
server.
Select [AutoIP] and press the [ENTER] key.
6
Select a setting value and press the
7
[ENTER] key.
• Setting value: ON / OFF
• Set to ON to use an IP address set by the AutoIP
protocol. Note that DHCP is given priority when
DHCP is set to ON.
Select [IP ADDRESS] and press the
8
[ENTER] key.
Select a setting value and press the
9
[ENTER] key.
• Setting value: ON / OFF
• You can set an IP address when both DHCP and
AutoIP are set to OFF. In other cases, go to step
14.
Press the
10
• Setting items for the default gateway, DNS
address, and subnet mask are displayed.
• You can set the default gateway, DNS address,
and subnet mask when both DHCP and AutoIP
are set to OFF. In other cases, go to step 12.
Select a setting item and press the
11
[ENTER] key.
Select a setting value and press the
12
[ENTER] key.
• Restart the machine to apply network settings.
Chapter 3 Settings
key.
3-11
1
2
3
4
5
6