MIMAKI TxF150-75 Operation Manual page 88

Chapter 5 Troubleshooting
Message
ERROR 509
HDC POSCNT
ERROR 50a
Y ORIGIN
ERROR 50f
L-SCALE BLACK
ERROR 529
LEnc.Count HPC[____]
ERROR 52a
LEnc.Count HDC[____]
ERROR 50c
MEDIA WIDTH SENSOR
ERROR 516
MEDIA SET POSITION R
ERROR 528
PUMP MOTOR SENSOR
ERROR 602
CARTRIDGE END
ERROR 608
WRONG INK IC
ERROR 612
INK LEVEL LOW
ERROR 613
INK LVL END
ERROR 614
Preservation Failure
ERROR 627
RE-INSERT CARTRIDGE
ERROR 628
WRONG CARTRIDGE
ERROR 702
THERMISTOR CONNECT
ERROR 710
HEATER TEMP ERROR
ERROR 901
INVAILD OPERATION
5-8
Cause
A position control error occurred.
Y-origin could not be detected.
Linear scale error.
The media width could not be read cor-
rectly.
The media was loaded outside the range
of valid positions.
Pump sensor detection error
Ink end (cannot be used for printing, only
when cleaning with the 4-color ink set)
The ink IC chip of the ink cartridge can-
not be read correctly.
Remaining cartridge volume is less than
60 ml when using 600 ml cartridges.
Remaining cartridge volume is less than
25 ml when using 600 ml cartridges.
Failed to write to the ink IC chip during
weight input when using 600 ml car-
tridges.
A certain amount of time has passed
since a cartridge was removed from a
slot.
An error occurred with the ink IC chip
information for the ink cartridge.
Amount used exceeds the stipulated
value.
Thermistor connection error.
Heater temperature error detected.
If the temperature issue is not resolved
after this error occurs, the machine is
forced to shut down.
An error has prevented the function from
being performed.
Corrective action
• Temporarily turn off the main power supply,
and then turn it on again.
If the message appears again, contact your
dealer, or our sales office or call center.
• Check the media loading position (
4).
• Clean the media sensors (
• Temporarily turn off the main power supply,
and then turn it on again.
• Check the media loading position (
4).
• Temporarily turn off the main power supply,
and then turn it on again.
If the message appears again, contact your
dealer, or our sales office or call center.
• Replace with new ink.
• Make sure that the cartridge is inserted cor-
rectly.
• Reinsert the cartridge.
• Temporarily turn off the main power supply,
and then turn it on again. If the message
appears again, contact your dealer, or our
sales office or call center.
• Enter the cartridge weight.
• Make sure that the cartridge is inserted cor-
rectly.
• Reinsert the cartridge.
• Temporarily turn off the main power supply,
and then turn it on again. If the message
appears again, contact your dealer, or our
sales office or call center.
• Load cartridges.
• Make sure there is no nozzle clogging.
• Temporarily turn off the main power supply,
and then turn it on again.
If the message appears again, contact your
dealer, or our sales office or call center.
• Return to the local screen, check the error
status, and respond appropriately.
P.2-
P.4-9).
P.2-