MIMAKI TxF150-75 Operation Manual page 87

Message
ERROR 18a
Main PCB V_CORE
ERROR 18c
Main PCB V12
ERROR 190
Main PCB V42-1
ERROR 192
COMIO PCB V1R2
ERROR 193
COMIO PCB V2R5
ERROR 194
COMIO PCB V3R3
ERROR 195
COMIO PCB V24
ERROR 1a0
SLDR2H PCB V1R2
ERROR 1a6
SLDR2H PCB V2R5
ERROR 1a7
SLDR2H PCB V3R3
ERROR 1a8
SLDR2H PCB V5
ERROR 1a9
SLDR2H PCB V42
ERROR 201
COMMAND ERROR
ERROR 202
PARAMETER ERROR
ERROR 304
USB INIT ERR
ERROR 305
USB TIME OUT
ERROR 401
MOTOR X
ERROR 402
MOTOR Y
ERROR 403
X Current
ERROR 404
Y Current
ERROR 505
MEDIA JAM
Cause
An error occurred in the main PCB power
supply.
An error occurred in the COM16 PCB
power supply.
An error occurred in the slider E PCB
power supply.
The machine received data other than
print data.
Otherwise, an error occurred with the
transmitted print data.
An error occurred with the transmitted
print data.
An error occurred with USB communica-
tion.
The X motor was overloaded.
The Y motor was overloaded.
An overcurrent error was detected in the
X motor.
An overcurrent error was detected in the
Y motor.
Media has jammed.
Chapter 5 Troubleshooting
Corrective action
• Temporarily turn off the main power supply,
and then turn it on again.
If the message appears again, contact your
dealer, or our sales office or call center.
• Securely connect the interface cable.
Use an interface cable conforming to the
specifications.
• Temporarily turn off the main power supply,
and then turn it on again.
If the message appears again, contact your
dealer, or our sales office or call center.
• Remove and reload the media.
1
2
2
2
5
5-7