Menu Mode - MIMAKI TxF150-75 Operation Manual

Menu Mode

The machine has four modes. Each menu mode is described below.
Not-Ready mode
The machine is in this mode before detection of media.
Local mode
In this mode, the machine is ready to print. All keys are available. The machine can receive data from a computer.
The following operations are available in local mode:
• Pressing the jog keys to set the print origin and print area.
• Checking remaining ink levels, cartridge error details, the model name, firmware version, and so on by pressing the
[Enter] key.
Screen display in local mode
Shows the current heater
temperature.
Icon color above the temperature
varies depending on the current
heater status.
Orange: Temperature rising
Green: At the specified
temperature
Gray: Heater off
Shows the functions
assigned to function keys
[FUNC1]–[FUNC3].

Menu mode

To enter menu mode, press the [FUNC1] key in local mode. This mode enables you to set each function.
Remote mode
In this mode, the machine prints data it receives.
LOCAL
width:1340mm
PRE PRINT
30 /40 30 /35
TEST PRINT
MENU
CLEANING
[SEL] key
Function keys [FUNC1]–[FUNC3]
Press the [SEL] key to switch functions.
Chapter 1 Before Use
Shows the detected media
width.
POST
40 /50
Shows the detected ink levels
(approximate).
REMOTE
1
2
2
2
5
6
1-13