When Ink Level Low Or Ink Near End Is Displayed; When Replace Inkpack (Ink End) Is Displayed - MIMAKI TxF150-75 Operation Manual

Chapter 1 Before Use

When Ink Level Low or Ink Near End is Displayed

This machine counts the consumed ink amount. Discrepancies in actual consumed ink amount can occur for some
reason. If the warning message appears, take appropriate actions as instructed on the operating panel.
LED Message
Ink level low
Lit in
INK NEAR-END
yellow
Ink level end
Lit in
Replace Inkpack (Ink End) The ink remaining in the
red
*1. The remaining ink amount is only a guide.

When Replace Inkpack (Ink End) is Displayed

The ink has run out. Replace with new Ink pack.
Thoroughly read the following and make sure you understand its contents.
• Pay close attention to ventilation and be sure to wear safety glasses, gloves, and a mask when handling ink, maintenance
liquid, waste ink, or other solutions used with the machine. Leaking ink may adhere to the skin or get into the eyes or
mouth.
• The ink in the ink pack cannot be used up completely. The ink pack is filled up with the amount of ink which is
slightly more than the indicated value. As ink end occurs when the indicated amount of ink is consumed, a small
amount of ink remains.
1-10
Machine operation
*1
Display condition
Printing
The ink remaining in the
Possible
cartridge is below 60 ml.
The ink remaining in the
cartridge is below 60 ml
Possible
after the weight of the
cartridge is corrected.
The ink remaining in the
Disabled
cartridge is below 30ml.
cartridge is below 30 ml
Disabled
after the weight of the
cartridge is corrected.
Corrective action
Cleaning
1. Remove the ink cartridge, and measure the
Disabled
weight. （ P.3-10 「Correcting the Ink
Cartridge Case Weight」)
2. Enter the measured weight into the
Disabled
machine. （
Ink Cartridge Case Weight」)
Disabled
1. Replace the ink pack.
（ P.1-11 「Replacing Ink」)
Disabled
P.3-10 「Correcting the