Cutting Media Manually - Oce Eco Solvent CS9350 Manual

4.3.4

Cutting media manually

CAUTION
Right after printing, the media guide becomes very hot.

Allow the media guide to cool down before the next operation.
Step 1:
Verify the following regarding the operational condition of the product.
• Printing or other operations are not in progress.
• The operation panel display is Normal.
Step 2:
To change the position to cut the roll media, refer to "4.4.1 Feeding media" and advance the
roll media to the desired cut position.
Step 3:
Place a razor blade on the media cut groove on the media guide, and cut the roll media.
CAUTION
Pay attention to the following points when cutting roll media.

Mishandling the razor blade may cause a cut on your finger or hand.
When you hold media, do not place your finger on the media cut groove.

Move the razor blade along the media cut groove.

1
2
3
N°
1
2
3
• The procedure for cutting the roll media is complete.
NOTE
When loading the new roll media, cut the front edge of the media if it is not straight.

Name
Media guide
Media cut groove
Razor blade
4-86
CS9350 User's Guide