Oce Eco Solvent CS9350 Manual page 52

Step 4:
Check the both ends and the centre of the print result that printed with Adjust pattern, and
select the number from 1 to 7 that is not out of alignment.
• "6" is selected in the next printing sample.
NOTE
"4" is the current setting value.

Step 5:
"Pattern *: 4" (* indicates a pattern name as shown below) is displayed on the operation
panel.
• The pattern name (*) differs depending on the set print mode.
The print modes and their pattern names are as follows.
PrintMode
Quality 1, 2
Quality 3, 4
Graphics 1, 2
Graphics 3, 4
Banner 1, 2
Banner 3, 4
Step 6:
Press the [+] key or [–] key to enter the number that you selected in Step 4.
PatternName
C
B
E
D
A
A
3-52
CS9350 User's Guide