Oce Eco Solvent CS9350 Manual page 105

CS9350 OPERATION MANUAL
User Type menu
Various settings on the user type settings are configured.
In the user type menu, 30 different settings can be set as Type 1 to 30 for the following printing operation.
NOTE
If media other than recommended one (user type) is used, the following problems may

occur.
Media detection error

Slant, torn, and wrinkle of media

Media jams

Favourable print quality cannot be obtained due to blots, blurs or dirt of ink.

End detection of roll media cannot be performed, etc.

The problems caused by the use of the media other than recommended one will not be

covered by the warranty and repair expenses will be paid by the customer.
For details, contact your local Océ representative.
Setup item
Type 1 to 30
Setting
PrintMode
Effect
Adjust Print
PF Adjust
Pre heater
Platen heater
Dryer
Vacuum Fan
—
5-105
Description
Sets up the Print Mode according to the usage of print data or
print speed.
•[Enter] key: shifts to the sub menu.
5.1.1.1.1 Print Mode menu
Sets up the Effect menu.
•[Enter] key: shifts to the sub menu.
5.1.1.1.2 Effect menu
Sets up when adjusting the printer for the optimum quality of
image print.
•[Enter] key: shifts to the sub menu.
5.1.1.1.3 Adjust Print menu
Sets up various settings on the media feed compensation.
•[>] key: shifts to the sub menu.
5.1.1.1.4 Dist.Adj menu
Sets the temperature of the pre-heater.
•[Enter] key: shifts to the sub menu.
5.1.1.1.5 Pre-heater menu
Sets the temperature of the platen heater.
•[Enter] key: shifts to the sub menu.
5.1.1.1.6 Platen heater menu
Sets the temperature of the dryer.
•[Enter] key: shifts to the sub menu.
5.1.1.1.7 Dryer menu
Sets up vacuum fan operation.
•[Enter] key: shifts to the sub menu.
5.1.1.1.8 Vacuum Fan menu
•[Cancel] key: shifts to the previous menu.
5.1.1 User Type menu