Oce Eco Solvent CS9350 Manual page 182

(2) The printing position is incorrect (some parts of the media cannot be printed
on)
N° Possible cause
1 Is the loading position of the media correct?
2 Did you set up the origin and print position?
(3) Printing is blurred
N° Possible cause
1 Are you using the recommended media?
2 Are you using the thick or thin media?
3 Is the media printed on the printing surface?
4 Did you perform Alignment?
5 Did you perform Media feed compensation?
6 Is the temperature setting of each heater
appropriate?
7 Is the head height set to High?
(4) White or black lines appear on printed media
N° Possible cause
1 Are you using the recommended media?
2 Is the scroller set correctly?
3 Is the nozzle in good condition?
4 Did you perform Alignment?
5 Did you perform Media feed compensation?
6 Is the temperature setting of each heater
appropriate?
7 Is the head height set to High?
Remedy
Set the media correctly.
Cancel or reset the settings of the origin and
print position.
Remedy
Use the recommended media.
Use the recommended media.
Confirm the printing surface of the media and
set it correctly.
Perform Alignment.
Perform Media feed compensation.
Set the temperature appropriately.
Return the head height to "Low".
Remedy
Use the recommended media.
Set the scroller correctly.
Perform Head cleaning.
Perform Alignment.
Perform Media feed compensation.
Set the temperature appropriately.
Return the head height to "Low".
7-182
CS9350 User's Guide
Reference
3.4 Loading
media
5 Panel setup
menu
Reference
4.2.1 Media type
4.2.1 Media type
3.4 Loading
media
3.6 Adjust Print
4.2.6 Media feed
compensation
5.1.1.1.5 Pre-
heater menu to
5.1.1.1.7 Dryer menu
4.2.5 Head
height adjustment
Reference
4.2.1 Media type
3.4.1 Loading
roll media
6.2.3 Head
cleaning
3.6 Adjust Print
4.2.6 Media feed
compensation
5.1.1.1.5 Pre-
heater menu to
5.1.1.1.7 Dryer menu
4.2.5 Head
height adjustment