Oce Eco Solvent CS9350 Manual page 187

CS9350 User's Guide
N° Display
28 Color measuring mode error
(Command)
29 Color measuring mode error
(Media End)
30 Color measuring mode error
(Cover Open)
31 Measurement Error
(Lever Lifted)
32 Measurement Error
(Communication)
33 Measurement Error
(Instrument)
34 Measurement Error
(Cancelled)
35 Measurement Error
(White Calibration)
36 Measurement Error
(Illegal Operation)
NOTE
[****] of the error display indicates the ink color that is subject to warning.

Description
The parameters of the
command sent from RIP
software are abnormal.
The media has run out while
printing or measuring the
color target.
Cover(s) opened while
measuring the color target.
The media loading lever is
raised while printing or
measuring the color target.
A communication error
occurred while printing or
measuring the color target.
A communication error with
spectrophotometer occurred
while measuring the color
target.
Printing or measuring the
color target has been
cancelled from the operation
panel or the RIP software.
White calibration has failed.
Colorimeter has been
installed forcibly without
following the proper color
measurement procedure.
7-187
Remedy
Check the settings of color
calibration or color profiling
of the RIP software.
Load new media and start
printing and measuring the
color target again.
Close the front cover and the
maintenance covers on both
sides of the printer.
Printing or measuring is
cancelled. Start printing and
measuring the color target
again.
Check the communication
requirements between the
printer and your PC.
Check the connection
between the printer and
spectrophotometer.
Start printing and measuring
the color target again.
•Open the maintenance cover
on the left side of the
printer and install the white
reference plate correctly.
•When the white reference
plate is contaminated,
apply a damp and tightly
squeezed soft cloth to clean
it.
•Start printing and measuring
the color target again.
•If you still have trouble,
contact your local Océ
representative.
Remove the colorimeter.
Reference
—
4.5 Using
spectrophotometer
3.4 Loading
media
6.2.4 Cleaning
the cleaning wiper
4.5 Using
spectrophotometer
Connecting the
printer to PC
4.5 Using
spectrophotometer
4.5 Using
spectrophotometer
4.5 Using
spectrophotometer
4.5 Using
spectrophotometer