Oce Eco Solvent CS9350 Manual page 78

a. Press the [+] key or [–] key on the operation panel to select "PF3: Confirm Print".
b. Press the [Enter] key on the operation panel.
• "Feed Length: 250 mm" is displayed on the operation panel.
TIP
The length of media that is fed (feeding length) for Confirm Print is normally set at 250

mm.
If you increase the feeding length, the accuracy of the Media feed compensation

improves.
To change the feeding length, press the [+] key or [-] key on the operation panel and
change the set value.
c. Press the [Enter] key on the operation panel.
• "Printing" is displayed on the operation panel.
• Starts Confirm Print.
1
N°
1
2
• When the Confirm Print is complete, the printer enters Normal.
d. After the Confirm Print, the media is cut.
4.4.3 Cutting media
Step 6:
Measure the distance between the two pluses in the Confirm Print using a ruler. Then, confirm
that the distance matches the feeding length when printing.
a. If the distance does not match the feeding length, follow the procedure from Step 1 to Step 5 and
readjust.
b. If the distance matches the feeding length, proceed to step 7.
Step 7:
Perform Micro Print.
a. Display the Dist.Adj menu on the operation panel in the same way as in step 1.
Name
Feed length
Media feeding direction
4-78
CS9350 User's Guide
2
1