Roll Length Menu; Longstore Menu - Oce Eco Solvent CS9350 Manual

5.1.17

Roll Length menu

Sets up the roll media length.
Setup item
Roll media
Roll Length menu
Sets up the roll media length.
NOTE
After replacing the roll media, set the roll media length again.

If the roll media length is not set, the residual quantity of roll media may not be displayed
correctly.
Setup item
Length
5.1.18

Longstore menu

Wash the print head with the cleaning fluid.
NOTE
Make sure to use the dedicated cleaning fluid.

Setup item
Longstore
Setting
<Off>
Roll1
Roll2
Roll3
—
Setting
1 m to <30 mm> to 99 mm
—
Setting
Start
Remove Cartridges
—
5-128
CS9350 OPERATION MANUAL
Description
Roll Length is not used.
•[Enter] key: saves the setting and shifts to the previous menu.
5.1 Setup menu
Sets up the roll media length.
The set values of the roll media length can be set as "Roll1" to
"Roll3".
•[Enter] key: saves the setting and shifts to the sub menu.
5.1.17.1 Roll Length menu
•[Cancel] key: cancels the setting and shifts to the previous
menu. 5.1 Setup menu
Description
Sets the roll media length.
•[Enter] key: saves the setting and shifts to the previous menu.
•[Cancel] key: cancels the setting and shifts to the previous
menu. 5.1 Setup menu
Description
Wash the print head with the cleaning fluid.
•[Enter] key: Performs the head washing operation.
The following content is displayed on the operation panel.
Remove the ink cartridge, and install the cleaning cartridge.
6.1.1 Replacing ink cartridges
•[Cancel] key: shifts to the previous menu without Head
washing. 5.1 Setup menu