CS9350 User's Guide
TIP
The length of media that is fed (feeding length) for Initial Print is normally set at 250 mm.
If you increase the feeding length, the accuracy of the Media feed compensation
improves.
To change the feeding length, press the [+] key or [-] key on the operation panel and
change the set value.
b. Press the [Enter] key on the operation panel.
•
"Printing" is displayed on the operation panel.
•
Starts Initial Print.
1
N°
1
2
•
When the Initial Print is complete, the printer enters Normal.
c. After the Initial Print, the media is cut.
4.4.3 Cutting media
Step 3:
Measure the distance between the two pluses in the Initial Print using a ruler.
Step 4:
Sets up Initial Adjust Change.
a. Press the [+] key or [–] key on the operation panel to select "PF2: Initial Change".
b. Press the [Enter] key on the operation panel.
•
"Init.: 250.0/250 mm" is displayed on the operation panel.
c. Press the [+] key or [-] key on the operation panel and enter the measured value in step 3.
d. Press the [Enter] key on the operation panel.
•
The initial adjustment value is saved.
•
"PF2: Initial Change" is displayed on the operation panel.
Step 5:
Performs Confirm Print.
Name
Feed length
Media feeding direction
4-77
2
1