Oce Eco Solvent CS9350 Manual page 108

Effect menu
Set up this menu when you want to improve print quality by adjusting the set Print Mode.
NOTE
The print quality may not be improved depending on the printing condition.

Setup item
Effect <None> *1
Wave
<Fog> *1
<Fine & Fuzz> *1
<Fine & Fog> *1
A-S.Fine & Wave
B-S.Fine & Wave
*1 The default value of the effect differs depending on the selected print mode as shown below.
Print Mode
Quality1 to 4
Graphics1 to 2
Graphics3 to 4
Banner1 to 2
Banner3 to 4
Setting
The Effect function is not used.
The printing joint will be the wave form.
The print quality may be improved than None.
The printing joint will shade off.
Set up this menu when obvious white lines or uneven print density
appear on printed media in "Wave".
Mode for low resolution (360 x 720dpi).
The printing joint will shade off as the wave form.
Perform the printing at slower speed than "Wave".
The printing joint will shade off.
Set up this menu to improve horizontal banding with Fine & Fuzz.
Perform the printing at a slower speed than Fine & Fuzz.
Performs "Wave" printing using the half of the print head nozzles.
Since only half of the print head nozzles are used, printing speed
becomes a half of "Wave".
Set up this menu to improve the print quality compared with "Fine &
Fuzz". If used when one side of the nozzles are clogged, quality
deterioration may be avoided.
Performs "Wave" printing using the half of the print head nozzles on
the opposite side of "A-S.Fine & Wave".
Since only half of the print head nozzles are used, printing speed
becomes a half of Wave.
Set up this menu to improve the print quality compared with "Fine &
Fuzz". If used when one side of the nozzles are clogged, quality
deterioration may be avoided.
— •[Enter] key: saves the setting and shifts to the previous menu.
•[Cancel] key: cancels the setting and shifts to the previous menu.
Fine&Fuzz
Fine&Fuzz
Fine&Fog
Fog
None
5-108
CS9350 OPERATION MANUAL
Description
5.1 Setup menu
Effect Default Value