Konica Minolta bizhub C658 Service Manual page 668

bizhub C658/C558/C458/C368/C308/C258
8.19.11 Left lower cover (FS-537/FS-537SD)
[2]
[1]
[3] [1]
[4]
3. Reinstall the above parts following the removal steps in reverse.
8.19.12 Finisher (FS-537/FS-537SD)
1. Open the front door of the finisher.
[2]
[3]
[4]
3. Remove the DF cable cover.
G.6.2.22 DF cable cover
[1]
[1]
[2]
1. Remove five screws [1], disconnect the connector [2], and remove the left
lower cover [3].
2. NOTE
▪ Always perform the installation after mounting three hooks [4] of the
left lower cover on the finisher plate.
2. Remove the screw [1] and pull out the lever [2].
NOTE
▪ During installation, when the pulled out lever is pushed down, the
finisher screw [3] must be inside the range of the lever installation
hole [4].
4. Disconnect two connectors [1] and the cable tie insertion part [2].
G-368
G DISASSEMBLY/REASSEMBLY > 8. Option