Konica Minolta bizhub C658 Service Manual page 684

bizhub C658/C558/C458/C368/C308/C258
[4]
[1]
[2] [3]
16. Reinstall the above parts following the removal steps in reverse.
8.19.24 Alignment motor/rear (M13) (FS-537/FS-537SD)
1. Remove the rear cover.
Rear cover (FS-537/FS-537SD)
[1]
[2] [3] [2]
[2]
[1]
5. Reinstall the above parts following the removal steps in reverse.
8.19.25 Alignment motor/front (M14) (FS-537/FS-537SD)
1. Remove the front lower cover.
G.8.19.7 Front lower cover (FS-537/FS-537SD)
[2] [1]
[1] [3]
[1]
15. Remove four screws [1], remove the belt [3] while sliding the metal plate [2],
then remove the trail edge stopper motor/F [4].
NOTE
▪ Place the belt [3] on the gear during installation.
2. Disconnect the connector [1].
3. Remove two screws [2], and remove the alignment motor/rear assy [3].
4. Remove two screws [1], and remove the alignment motor/rear [2].
2. Remove two screws [1] and the connector [2], then remove the alignment
motor/front assy [3].
G-384
G DISASSEMBLY/REASSEMBLY > 8. Option