Konica Minolta bizhub C658 Service Manual page 510

bizhub C658/C558/C458/C368/C308/C258
NOTE
▪ Be sure to perform the following operation when the document width size sensor is replaced.
▪ Execute [Service Mode] -> [ADF] -> [Original Tray Width].
I.5.21.6 Original Tray Width
▪ Turn OFF the main power switch and turn it ON again and check whether size detection operates normally.
8.3.8 Document reading motor (M1) (DF-629)
1. Remove the rear cover.
G.8.3.2 Rear cover (DF-629)
2. Remove the reading roller release motor.
G.8.3.12 Reading roll release motor (M5) (DF-629)
[4] [2]
[3] [1]
[1] [2]
[1]
[1]
7. To reinstall, reverse the order of removal.
8.3.9 Document feed motor (M2) (DF-629)
1. Remove the rear cover.
G.8.3.2 Rear cover (DF-629)
[1]
3. Remove the spring [1], and remove three screws [2].
4. Disconnect the connector [3], and remove the document reading motor assy
[4].
5. Remove two screws [1], and remove the document reading motor [2].
6. NOTE
▪ For mounting it, set the document reading motor to the belt position
[1] shown on the illustration.
2. Lift up the document feed tray [1].
G-210
G DISASSEMBLY/REASSEMBLY > 8. Option