Konica Minolta bizhub C658 Service Manual page 935

bizhub C658/C558/C458/C368/C308/C258
[1] Arrow key
5.16.35 Smart Fusing Control
(1) Use
• Specifies whether or not to apply low power fusing control.
• For details of the low power fusing control, see "Smart fusing control".
[Permit]
[Prohibit]
(2) Default setting
• Permit
(3) Setting item
• Permit
• Prohibit
5.16.36 Clean Unit Setting
(1) Use
• bizhub C368/C308/C258: Use this feature upon optional clean unit CU-101 set-up.
• bizhub C658/C558/C458: Use this feature upon optional clean unit CU-102 set-up.
(2) Default setting
• Nott Installed
(3) Setting item
• Installed
• Nott Installed
5.16.37 Auth. Function Enable
(1) Activation
(a) Use
• Use to activate the advanced function after certification.
(b) Procedure(Entering function codes manually)
1. Call the Service Mode to the screen.
2. Touch [System 2] -> [Auth. Function Enable] -> [Activation].
3. Confirm that [Function Code] is selected, and the press the [Function Code].
4. Enter the function code and press [OK].
5. Confirm the instructions on-screen and press [Confirm].
(c) Procedure(Importing function codes via a USB device)
1. Connect the USB device that contains the functions codes to be activated.
2. Call the Service Mode to the screen.
3. Touch [System 2] -> [Auth. Function Enable] -> [Activation].
4. Confirm that [USB] is selected.
NOTE
▪ [USB] is only displayed when a USB device that contains functions codes to be activated is connected.
5. Confirm the instructions on-screen and press [Confirm].
(2) List
[1]
Applies low power fusing control by lowering the target temperature as much as possible in response to the
single sheet data. Cuts down electric power consumption (TEC value).
Controls the adjustment of the specified fusing temperature.
I ADJUSTMENT/SETTING > 5. SERVICE MODE
- -
I-165