Konica Minolta bizhub C658 Service Manual page 414

bizhub C658/C558/C458/C368/C308/C258
11. Remove the protective shield.
G.6.2.26 Protective shield
12. Open the PWB box/1.
G.6.3.9 How to open the PWB box/1
13. Remove the left cover.
G.6.2.16 Left cover
14. Remove the exit cover.
G.6.2.17 Exit cover
15. Remove the output rear cover.
G.6.2.18 Output rear cover
16. Remove the expansion control board.
G.6.4.12 Expansion control board (EXCB)
17. Remove the fusing motor.
G.6.5.3 Fusing motor (M3)
18. Remove the fusing pressure motor.
G.6.5.15 Fusing pressure motor (M11)
[1]
[2]
[1]
[1]
[2] [3]
[1]
[3] [2]
[2]
[2] [1] [2]
19. Remove the harness from the edge cover [1], and disconnect two connectors
20. Remove four screws [1], the ground terminal [2], and remove the plate [3].
21. Remove the cable from five saddles [1].
[1]
22. Remove four screws [2], and remove the plate [3].
[1]
23. Remove the harness from two wire saddles [1].
24. Disconnect four connectors [2].
G DISASSEMBLY/REASSEMBLY > 6. bizhub C658/C558/C458
[2].
G-114