Konica Minolta bizhub C658 Service Manual page 470

bizhub C658/C558/C458/C368/C308/C258
[1]
[2]
[1]
[3]
10. To reinstall, reverse the order of removal.
6.8.4 Developing solenoid (SD4)
1. Remove the duct cover.
G.6.2.23 Duct cover/1
G.6.2.24 Duct cover/2, filter assy
2. Remove the toner filter.
F.8.1.1 Replacing the toner filter
3. Remove the lower rear cover.
G.6.2.21 Lower rear cover
4. Remove the protective shield.
G.6.2.26 Protective shield
5. Open the PWB box.
G.6.3.9 How to open the PWB box/1
6. Remove the high voltage unit.
G.6.4.11 High voltage unit (HV)
[2] [3] [1]
[6] [5] [4]
10. To reinstall, reverse the order of removal.
6.8.5 Soaking roller pressure solenoid (SD5) (bizhub C658/C558)
1. Remove the ADU transport unit.
G.6.3.18 ADU transport unit
[2]
[1]
[2]
G DISASSEMBLY/REASSEMBLY > 6. bizhub C658/C558/C458
7. Remove the screw [1], and remove the cover [2].
8. Remove the screw [1].
9. Remove the gate switch solenoid [3] as clearing the actuator [2].
7. Disconnect the connector [1], and remove the harness from the edge cover [2]
and the wire saddle [3].
8. Remove the harness from the harness guide [4].
9. Remove the screw [5], and remove the developing solenoid [6].
2. Remove two screws [1], and remove the duct [2].
G-170