Konica Minolta bizhub C658 Service Manual page 151

bizhub C658/C558/C458/C368/C308/C258
Effective scanning range
Automatic reduction at sending
Rotation transmission
Page division at sending
Halftone
Automatic background control (ABC)
Finished stamp
Scanning time
25.1.3 Recording section
Recording
Recording paper size
Recording paper cassette
Staple
Recording speed
Recording size
Maximum reception length
Reduction record
Page separation record
Offset output at each communication
Rotation reception
Two-sided reception
2-in-1 reception
Smoothing
Print/Fax output settings
Bypass print
Total page counter
Monitor print
25.1.4 Line connecting section
NCU type
Connecting terminal
Modem
Modem sending level
DTMF sending level
Receiving sensitivity
Dialing signal
25.1.5 Control panel section
FAX / copy / scan / box
Long original mode
When a document is smaller than the effective scanning area, the area outside the document is
erased.
• DF scanning: left, right, head and bottom mask of 3mm each (0 to 5mm)
• Platen scanning: left, right and head mask of 2mm each (fixed)
A3 -> B4, A3 -> A4 and B4 -> A4
• Automatically reduced and sent in accordance with the recording paper size of remote station.
A4 / Letter size only. LEF documents are rotated by 90 degrees at sending to send it in SEF
direction.
No
256 level error diffusion
• Users can change settings by using the [Text], [Text/Photo, Printed], [Text/Photo, PhotoPaper],
[Photo, Printed], [Photo, PhotoPaper], [Dot Matrix Original] or [Copied Paper] key.
Yes
Yes
80 sheets/min (When DF is installed, letter (81/2 x 11) or A4, scanning, 300dpi)
Laser electrostatic printing system
• All sizes except for B6 and Postcard (See the copier basic specifications.)
• Auto recording paper selection
• Note: A5 and B5 paper is used only for A5 and B5 reception respectively
• Tray 1 to Tray 4
• Manual bypass tray
• LCT
No
Compliant to the copier standards
A3 size maximum
• A3 fix as reception record ability declaration in protocol.
1000 mm
• In case of being larger than the maximum reception length, a communication error occurs.
• When the memory over occurs during reception, the received data is printed.
When the received image information is larger than the recording paper, it is automatically reduced
to the recording paper size and recorded.
Yes
Yes (Job unit reception only)
Yes
• Images are rotated by 90 degrees and recorded on the recording paper in LEF direction.
Yes (Utility Mode)
No
Yes (at converting the resolution)
Yes
Possible to use as an active tray in auto selection mode.
Yes
No (copy at sending)
A-A~, line control by silicon DAA
RJ11
Matsushita MMD-5020
-10 to -15 dBm (Country spec)
-10 to -15 dBm (Country spec)
• G3 reception: up to -48 dB
• Tone reception: up to -52 dB
DP (10pps) and DTMF
Mode switching by panel key selection
Initial screen after power- Screen at power off or facsimile screen.
on (depending on parameter setting)
C-53
C PRODUCT SPECIFICATIONS > 25. FK-514/FK-515
• 1000 mm
• Originals with unlimited length are not available.
• Possible to change modes during an operation of each mode.
• No mode return by the auto reset.