Konica Minolta bizhub C658 Service Manual page 346

bizhub C658/C558/C458/C368/C308/C258
[1]
[1]
[1]
6. To reinstall, reverse the order of removal.
5.4.9 Machine condition monitor board (MCMB)
1. Remove the control panel right cover.
G.5.2.8 Control panel right cover
[1]
[1]
[2]
[2]
[1]
[1]
G DISASSEMBLY/REASSEMBLY > 5. bizhub C368/C308/C258
3. Disconnect all connectors and solderless terminals on the high voltage unit.
4. Remove four screws [1] of the high voltage unit.
NOTE
▪ When installing the high voltage unit, tighten the screws in the order
shown in the illustration.
5. Unhook the tab [1], and remove the high voltage unit [2].
NOTE
▪ When mounting the high voltage unit, the terminal contact point
must be contacted without fail. The claw also must be firmly hooked.
2. Remove two caps [1].
3. Remove five screws [1] from the control panel front cover [2] and remove the
cover by releasing the tabs.
G-46