Konica Minolta bizhub C658 Service Manual page 732

bizhub C658/C558/C458/C368/C308/C258
[1]
[3] [2] [4]
[2]
[1]
[2]
[2]
[1]
10. To reinstall, reverse the order of removal.
11. After replacing, conduct hard disk mirroring.
[State Confirmation] -> [Memory/Storage Adjustment] ->
8.33.2 Hard disk (B) (HD-524: Cover type) (bizhub C368/C308/C258)
1. Remove the lower rear cover.
G.5.2.20 Lower rear cover
[3]
[1]
[1]
[3]
[2]
3. Remove the harness from the wire saddle [1].
4. Remove the harness from the edge cover [2].
5. Disconnect two connectors [3].
NOTE
▪ When the ferrite core [4] has been installed, be sure to install the
hard disk at the position shown in the illustration.
▪ Ensure that the cables do not contact with the MFP board at
connecting the connectors [3].
▪ When the video interface kit VI-508 has been installed, ensure that
the cables do not contact with the relay circuit board at connecting
the connectors [3].
6. Remove two screws [1], and remove two ground wires [2].
7. Remove the hard disk assy [3].
8. Remove four screws [1], and remove the metal plate [2].
9. Remove four metal plates [2] and two connectors [3] from the hard disk [1].
[HDD Mirroring Rebuild]
G-432
G DISASSEMBLY/REASSEMBLY > 8. Option