Konica Minolta bizhub C658 Service Manual page 591

bizhub C658/C558/C458/C368/C308/C258
[2]
[1]
[1]
[3] [4]
[5] [2]
[6]
5. To reinstall, reverse the order of removal.
8.11.3 Job separator (JS-506)
[4]
[3]
[3]
[7]
[1]
[2]
2. Remove two claws [1] and move the exit tray 2 [2] upward.
3. Slide the exit tray 2 [2] to unlock the claws [3], and remove the exit tray 2 [2].
4. NOTE
▪ When mounting the exit tray 2, mount the exit tray 2 in the following
step so that the shaft [2] of the actuator can be set to the groove [1]
of the exit tray 2.
▪ Adjust the actuator [5] so that the positioning marks [3] and [4] will
be aligned.
▪ Press the exit tray 2 down with the positioning mark [6] for the exit
tray 2 and the positioning mark [7] for the shift unit being aligned.
1. Remove the screw [1], and remove the cover [2].
NOTE
▪ When mounting the cover, insert two claws [3] into the holes on the
main unit cover first. Then fit two claws [4] into the holes. Be careful
not to pinch the harness.
G-291
G DISASSEMBLY/REASSEMBLY > 8. Option