Konica Minolta bizhub C658 Service Manual page 885

Hide thumbs Also See for bizhub C658:

Table of Contents

bizhub C658/C558/C458/C368/C308/C258

(2) Default setting

(3) Setting item

5.6.14 Manual Toner Add

(1) Manual Toner Add

• To adjust the set T/C level by replenishing an auxiliary supply of toner when a low ID occurs due to a lowered T/C after large numbers

of prints have been made of originals having a high image density.

• When there is a drop in T/C ratio.

(b) Procedure

1. Call the Service Mode to the screen.

2. Touch [Imaging Process Adjustment] -> [Manual Toner Add].

3. Select the color, for which supply of toner is to be replenished.

4. Pressing the Start key will let the machine detect the current toner density and; if the density is lower than a reference value, a toner

replenishing sequence and then a developer agitation sequence are run.

5. Operation above is repeated maximum of ten sets of times with one set consisting of three sequences until it reaches to the reference

value. When it is higher than the reference value, only the agitation is conducted.

(2) Hopper Toner Filling

• To fill the sub hopper with toner and perform agitate in the developing unit.

• Used when toner is manually supplied to the toner hopper and agitate in the developing unit is performed.

(b) Procedure

1. Call the Service Mode to the screen.

2. Touch [Imaging Process Adjustment] -> [Manual Toner Add] -> [Hopper Toner Filling].

3. Press the Start key to start filling and agitating operations.

5.7 CS Remote Care (Outlines)

• CS Remote Care enables the machine and the computer at CS Remote Care center to exchange data through telephone/fax line, network

or E-mail in order to control the machine.

• CS Remote Care enables the machine to call the computer at the center when trouble occurs. It also enables the computer at the center to

contact the machine for the necessary data.

• Data which CS Remote Care handles can be divided into the following groups.

• Data which show the status of use of the machine such as total count, PM count.

• Data which show the abnormal situation on the machine such as where and how often errors occur.

• Data on adjustment

• Data on setting

I ADJUSTMENT/SETTING > 5. SERVICE MODE

Show Quick Links

Table of Contents