Toshiba e-STUDIO5540C Service Manual page 99

[ED10] Skew adjustment motor (M1) home position detection abnormality
Classification
Finisher jam
Check item
Finisher
Skew adjustment motor (M1)
Skew HP sensor (S2)
Punch controller board
Replace parts
Skew adjustment motor (M1)
Skew HP sensor (S2)
Punch controller board
[ED11] Sideways adjustment motor (M2) home position detection error
Classification
Finisher jam
Check item
Finisher
Sideways adjustment motor (M2)
Sideways deviation HP sensor (S3)
Punch controller board
Replace parts
Sideways adjustment motor (M2)
Sideways deviation HP sensor (S3
Punch controller board
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
The Skew adjustment motor is not at the home position. [MJ-
1103/1104 (when MJ-6102 is installed)]
• Check if there is any paper in the finisher. Remove it if
there is.
• Motor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Connector check
• Board check
The Sideways adjustment motor is not at the home position.
[MJ-1103/1104 (when MJ-6102 is installed)]
• Check if there is any paper in the finisher. Remove it if
there is.
• Rotate sideways adjustment motor and fix its mechanism
if it does not rotate smoothly.
• Motor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Connector check
• Board check
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 98
Error item
Measures
Remarks
Error item
Measures
Remarks