Toshiba e-STUDIO5540C Service Manual page 749

Sub
05/08 Mode Element
element
05 Adjustmen Process Transfer 1st transfer bias
t mode constant-current
transformer
calibration value (C
only)
05 Adjustmen Scanner Scanner
t mode
05 Adjustmen Scanner Scanner Image location
t mode adjustment
05 Adjustmen Scanner Scanner Image location
t mode adjustment
05 Adjustmen Scanner Scanner Reproduction ratio
t mode adjustment
05 Adjustmen Scanner Scanner Distortion mode
t mode
05 Adjustmen Scanner Scanner Shading position
t mode adjustment
05 Adjustmen Scanner Scanner Shading position
t mode adjustment
05 Adjustmen Scanner RADF Adjustment of RADF
t mode paper alignment
05 Adjustmen Scanner RADF Adjustment of RADF
t mode paper alignment
05 Adjustmen Scanner RADF
t mode
05 Adjustmen Scanner RADF
t mode
e-STUDIO5560C/6560C/6570C (Ver08)
Sub-
Item Subitem Code
code
2993
3009
3030
3031
3032
3033
3034
3035
3040
3041
3042
3043
Default Acceptable
Details
value value
1 High 50 0-99
Log table switching for 0 0-4
RADF copying (color)
Primary scanning 113 0-255
direction (scan.
section)
Secondary scanning 124 68-188
direction(scan.section
)
Adj. secondary 128 0-255
scan.direction
Distortion mode - -
Original glass 117 68-188
RADF 133 68-188
Front side 12 0-20
Back side 5 0-20
Fine adjustment of 50 0-100
RADF transport speed
RADF sideways 128 0-255
deviation adjustment
30
RAM Contents
M (Unit: μA)
SYS 0: Same log table as the one used at copying with
original glass
1: Background reproduction - Light 2
2: Background reproduction - Light 1
3: Background reproduction - Dark 1
4: Background reproduction - Dark 2
SYS When the value increases by "1", the image shifts by
approx. 0.0423 mm toward the front side of the paper.
SYS When the value increases by "1", the image shifts by
approx. 0.09 mm toward the trailing edge of the paper.
SYS When the value increases by "1", the reproduction ratio
in the secondary scanning direction (vertical to paper
feeding direction) increases by approx. 0.025%.
- Moves carriages to the adjustment position.
SYS 0.09524 mm/step
SYS 0.09524 mm/step
SYS When the value increases by "1", the aligning amount
increases by approx. 0.4 mm.
SYS When the value increases by "1", the aligning amount
increases by approx. 0.4 mm.
SYS When the value increases by "1", the reproduction ratio
of the secondary scanning direction on original (fed
from the RADF) increases by approx. 0.1%.
SYS When the value increases by "1", the image of original
fed from the RADF shifts toward the rear side of paper
by approx. 0.0423 mm.
Proce Servic
dure e UI
4
1
1 Yes
1 Yes
1 Yes
6 Yes
1
1
1 Yes
1 Yes
1 Yes
1 Yes